Smooth operation method
--When operating, the stability of the machine can not only improve the work efficiency, prolong the life of the machine, but also ensure the safety of operation (put the machine on a flatter ground).
--The driving sprocket has better stability in the rear side than in the front side, and can prevent the final drive from external impact;
--The wheelbase of the track on the ground is always greater than the wheelbase, so the stability of the forward work is good, and the lateral operation should be avoided as far as possible.
--To keep the dig site close to the machine to improve stability and excavator; If the digging point is far away from the machine, the operation will be unstable because the center of gravity moves forward; Lateral excavation is less stable than forwarding excavation. If the excavation site is far from the center of the body, the machine will be more unstable.
--Therefore, the excavation site should be kept at an appropriate distance from the center of the body to make the operation balanced and efficient.

Correct walking operation
--When the excavator is walking, it should try to pack up the working device and close to the center of the body to maintain stability; Put the end drive behind to protect the end drive. Avoid driving over obstacles such as stumps and rocks as much as possible to prevent tracks from twisting; If you must drive over an obstacle, make sure the track center is on the obstacle.
--When crossing the mounds, the chassis is always supported by working devices to prevent the car body from shaking violently or even tipping. It should be avoided to idle the engine on a steep slope for a long time, otherwise, it will lead to poor lubrication due to the change of oil level Angle.

--Machine long-distance walking will make the support wheel and the final drive internal rotation for a long time to produce high temperature, oil viscosity decline, and poor lubrication, so should often stop cooling, prolong the life of the lower body.
--Do not rely on the driving force of walking to excavate the earth, otherwise, the excessive load will lead to the early wear and destruction of the final drive, track, and other parts of the vehicle.
--When walking uphill, the wheel should be driven behind to increase the adhesion of the track that touches the ground.
--When walking downhill, the driving wheel should be in front of the upper track to tighten up, to prevent the car body from sliding forward under the action of gravity and causing danger.
--When walking on the slope, the working device should be placed in front of you to ensure safety. After stopping, gently insert the bucket into the ground and put a block under the track.
--When walking on a steep slope, you should slow down and turn the left track backward when turning left, and turn the right track backward when turning right, which can reduce the danger of turning on the slope.







